SCAFSOFT — The Complete Guide: Free Design of Scaffold Ties to the Facade
SCAFSOFT by ADIT focuses on the part of a scaffold that usually goes undocumented — the ties to the building. The tool checks scaffold ties and their fixings into the facade against wind and service loads, and produces a report for submission. It runs in the browser, with a Hebrew interface, nothing to install and no registration.
SCAFSOFT — scaffolding design
ADIT Ltd (ADIT)
Designs scaffolding and the anchors that tie it to the structure.
Get it from the vendorWhat you get
- Scaffold ties — checks on the ties that hold the scaffold to the building.
- Facade fixing — a check of the anchor for each tie.
- Wind loads — a key load case for an external scaffold.
- Service loads — the loads from work on the scaffold.
- Report for submission — full documentation of the calculation.
Who it suits
Site engineers, scaffolding contractors and safety officers who need to document the tie arrangement. The tool deals with the ties and their fixings, not with the design of the whole scaffold structure.
Related tools
For formwork design — FORMSOFT. For curtain wall and glazing fixings — FACADESOFT. For full anchor design in concrete — AAS.
FORMSOFT — formwork design
ADIT Ltd (ADIT)
Designs formwork and its anchoring for concrete pours.
Get it from the vendor
FACADESOFT — curtain wall and glazing design
ADIT Ltd (ADIT)
Designs curtain wall and glass facade fixings.
Get it from the vendor
AAS — concrete anchor design
ADIT Ltd (ADIT)
Designs anchors into concrete for the full range of failure modes.
Get it from the vendorThe bottom line
SCAFSOFT closes a common documentation gap on building sites — free and in the browser.
Disclosure: the owner of this site also owns ADIT.